Heat Transfer In Forced Convection Thermal Demo Equipment Vocational Training Equipment

SR3204 Heat Transfer In Forced Convection Thermal Demo Equipment Vocational Training Equipment

Objective:

To Determine Average Surface Heat Transfer Coefficient For A Pipe By Forced Convection

Comparison Of Heat Transfer Coefficient For Different Airflow Rates And Heat Flow Rates

To Plot Surface Temperature Distribution Along The Length Of Pipe

Utilities Required:

Electricity Supply: 1 Phase, 220 V Ac, 2 Amp

Table For Set-Up Support, control panel, instruction manual in English and other accessories

Technical Details:

Test Section : Horizontal, Externally Heated

Diameter: 28 Mm (Approx.)

Length: 400 Mm (Approx.)

Blower: Fhp Of Standard Makes

Heater: Nichrome Wire

Air Flow Measurement: Orifice Meter & Manometer

Control Panel Comprising Of

Digital Voltmeter: 0-300 Volt

Digital Ammeter: 0-2 Amp

Variac: 0-230 V, 2 Amps

Digital Temp. Indicator: 0-3000c, With Multi-Channel Switch

Temperature Sensors: Rtd Pt-100 Type

With Standard Make On Off Switch, Mains Indicator Etc