Instrumentation Training Kit Electrical Engineering Training Equipment Teaching Equipment

SS1102C Instrumentation Training Kit Electrical Engineering Training Equipment Teaching Equipment

1. The introduction of the experimental device

The electronic training device, including the basic electrical experimenter, includes a host and a template unit. The host unit includes various measuring instruments, waveform generators, and power modules; the template unit has eleven templates each containing an eight-digit DIP switch, so the experiment on each template can use this switch to arrange appropriate faults. Let students practice troubleshooting. See Appendix 1 for the relative position of the fault repair switch. The fault switch of each template is factory-based, based on the principle that the circuit works normally. Place the switch in the normal position after troubleshooting.

1. Technical parameters

(1) Input power: two-phase three-wire system 220V±10% 60Hz

(2) Weight: Around <50kg

III. Training Kit including Installation, Commissioning and Testing

Kits consisting of the following modules:

Temperature Regulator with PID controller

Thermal Sensors (Photoconductive cell, Phototransistor, Linear variable differential transformer- LVDT)

Buffers and Inverters

Comparator with switchable hysteresis

Amplifiers with gain and offset control (Current amplifier， Summing amplifier, Differential amplifier, Instrumentation amplifiers )

Filter (Low-pass filter with switchable time constant)

Integrator and Differentiator with switchable time-constant

Voltage/Frequency and Voltage/Current converters

Operating voltage: 230V (50 Hz)

Warranty Period: Minimum One Year on equipment