Linear Circuit Lab Teaching Equipment Electrical Laboratory Equipment Vocational Training Equipment

SS1101C Linear Circuit Lab Teaching Equipment Electrical Laboratory Equipment Vocational Training Equipment

1. The introduction of the experimental device

The electronic training device, including the basic electrical experimenter, includes a host and a template unit. The host unit includes various measuring instruments, waveform generators, and power modules; the template unit has eleven templates each containing an eight-digit DIP switch, so the experiment on each template can use this switch to arrange appropriate faults. Let students practice troubleshooting. See Appendix 1 for the relative position of the fault repair switch. The fault switch of each template is factory-based, based on the principle that the circuit works normally. Place the switch in the normal position after troubleshooting.

1. Technical parameters

(1) Input power: two-phase three-wire system 220V±10% 60Hz

(2) Host power module:

III. Experiment list

(1) Basic electricity experiment

Experiment 1: DC RC circuit and transient phenomenon experiment

Experiment 2: Transformer characteristics experiment

Experiment 3: Parallel resonant circuit experiment

(2). Magnetic experiment

Experiment 1: Introduction of magnetic components

Experiment 2: Magnetic field experiment

Experiment 3: Ampere’s rule experiment

(3). Electronic circuit basic experiment

Experiment 1: Diode characteristics experiment

Experiment 2: Rectifier circuit experiment

Experiment 3: Zener diode characteristics experiment

Experiment 4: LED characteristics experiment

Experiment 5: Transistor Polarity Identification and Characteristic Experiment

Experiment 6: FET characteristics experiment

Experiment 7: SCR characteristics experiment

Experiment 8: UJT characteristic experiment

(4) Basic electronic circuit experiment

Experiment 1: Simple Amplifier Experiment

Experiment 2: Simple Complementary Amplifier Experiment

Experiment 3: Simple Voltage Regulator UK

Experiment 4: Push-pull amplifier circuit experiment

Experiment 5: Controlled Brightness Bulb Experiment

Experiment 6: Multi-stage serial amplifier experiment

Experiment 7: Relay Characteristics Experiment

Experiment 8: Touch Switch Experiment

(5) Other electronic parts characteristics experiment and application

Experiment 1: Light control circuit experiment

Experiment 2: Thermal Control Circuit Experiment

Experiment 3: Sound Control Circuit Experiment

(6) Oscillator characteristics experiment and application

Experiment 1: Intermittent oscillator characteristic experiment

Experiment 2: Electronic buzzer experiment

Experiment 3: Multivibrator characteristics experiment

Experiment 4: LC resonant circuit experiment